- 18 -
3.
Hang one end of shelf light housing on the front notch of a shelf bracket and then the other end of shelf
light housing on the notch of the shelf bracket on the opposite end. Repeat for each additional shelf
tiers. NOTE: On models without shelf lights, use a shelf support instead of a shelf light housing.
4.
Push shelf light cords into clear plastic clip located on inside of shelf brackets.
5.
Remove the cap from the appropriate female light sockets. If socket is not being used for a shelf light,
the cap must be plugged into socket for entire light system to operate. NOTE: Grip each side of cap
firmly and wiggle and pull cap straight out of socket. Do not roll cap during removal.
6.
Plug in each shelf light by aligning the male pins on the appropriate shelf light cord plugs with the
female light sockets and push together. NOTE: Do not roll plug during insertion.
7.
Hang one end of the shelf support on to the rear notch of one shelf bracket and then on the rear notch of
the shelf bracket on the opposite side. Repeat for additional shelf tiers.
8.
Place supplied shelving onto shelf supports as outlined in the appropriate “Shelf Installation” section of
this manual.
9.
On units with sliding rear doors, re-install both rear doors by lifting top of door into top track and
swinging bottom of door onto bottom track. Install door labeled “inner door” first on inner track and
door labeled “outer door” second on outer track.
Shelves and shelf light quantity
It is not required that all shelves and shelf lights supplied with each case are used. The quantity of shelves
and shelf lights can be tailored to your specific needs. If the supplied quantity of shelves and shelf lights
are not required, cap unused female socket located in interior of the case mullion with caps supplied.
Failure to do so will prevent entire lighting system from operating.
Wire Shelves Installation
WIRE SHELF,
PUSH INTO CLIPS ON
REAR SHELF SUPPORT
WIRE SHELF RETAINER CLIP & SCREW,
SCEW TO EACH END OF SHELF
SUPPORT ON BOTH SUPPORTS
(WIRE SHELF MODELS ONLY)
WIRE SHELF
PUSH REAR WIRE
INTO WIRE SHELF
CLIP
1.
For first time installation, it may be necessary to attach the clear plastic clips to each end of the rear
shelf supports. Use the 6-32 x ¼ flat head screws supplied with unit to attach clear plastic clips to the
1/8 hole on each side of shelf support. This step may have already been performed at the factory for
you. Repeat for each rear shelf support tier. (See illustration E1594-2 Detail C) NOTE: On 73” long
shelf supports, attach (2) additional clear plastic clips into 1/8 holes near the center of rear shelf
supports.
2.
With rear sliding doors removed, place front of wire shelf onto front shelf light. (On front shelf support
for models without shelf lights)
3.
Snap the rear of shelf into the clear plastic clips on rear shelf support.
4.
Repeat 2 & 3 for each tier.
