- 19 -
Glass Shelves Installation
GLASS SHELF RETAINER,
CLEAN GLASS WITH RUBBING
ALCHOL & ATTACH RETAINER
O BOTTOM CORNER OF GLASS.
(GLASS SHELF OPTION ONLY)
GLASS SHELF, AFTER RETAINERS
ARE ATTACHED RETAINER
STRADDELS REAR SHELF SUPPORT
(GLASS SHELF OPTION ONLY)
GLASS SHELF CLEAR BUMPER
ATTACH TO SHELF LIGHT
FOR FRONT OF GLASS TO SET ON.
(GLASS SHELF OPTION ONLY)
GLASS SHELF RETAINER
TO BE LOCATED, IN FAR
CORNER OF GLASS SHELF
FLUSH WITH EDGES
1.
For first time installation attach (2) glass shelf holders to each glass shelf. Remove backing from tape
located on flat side of glass shelf holder. Position the glass shelf holders in the (2) far corners of glass.
Repeat for each glass shelf. Attach a clear bumper on both sides of the light housing top surface for the
front of the glass to set on. This step may have already been performed at the factory for you.
NOTE: Clean area of glass where glass shelf holder is to be located with rubbing alcohol and let air
dry before installing shelf glass holder.
2.
With rear sliding doors removed, place front of glass shelf onto front shelf light. (On front shelf
support for models without shelf lights.)
3.
Let the rear of the glass shelf onto the rear shelf support so that the glass shelf holder straddles the rear
shelf support. If clear plastic clips were factory-installed on top of rear shelf support, remove and
discard clear plastic clips.
4.
Repeat steps 2 & 3 for each tier.
Metal Selves Installation
METAL SHELF
METAL SHELF
ALIGN SLOT IN SHELF
WITH TAB ON FRONT
OF SHELF BRACKET.
1.
With rear sliding doors removed, place front of the metal shelf onto front shelf light. (On front shelf
support for models without shelf lights)
2.
Align slots on each side of the shelf with the tabs on the front of each shelf bracket.