IMSS E3265
- 16 -
Shelves
The IMSS has solid metal shelves with LED lighting as standard.
There are (4) brackets required for each shelf (2 long brackets and (2) short
brackets. The long brackets are for the long side of case and the short brackets
are at the short end of case. The short bracket with cord retainer clip must be
used at the short end of case where the light cord plugs in.
The shelves are adjustable in ~ 1 1/16” increments.
SHORT SHELF
BRACKET WITH
CORD CLIP
CORD CLIP
SHORT SHELF
BRACKET
LONG SHELF BRACKETS
1. Turn the light switch to the off position.
2.
Follow the instruction in the illustration below and insert (1) of the (4) shelf brackets
in the desired tower slot on one side of the case. Place the additional shelf brackets
in the same height level on the opposite end of case. The (2) short brackets must go
on the short end and (2) long brackets must go on the long end. The short bracket
with a shelf light cord retainer clip must be on the side with the shelf light receptacle
.
4
1
2
3
4
INSTALLATION
REMOVAL
2
3
1
TOP HOOK
BOTTOM TAB
SHELF BRACKET
TOWER
1. Place shelf bracket top hook into desired slot in
the tower.
2. Lift shelf bracket top hook to allow shelf bracket
bottom tab to clear slot in tower.
3. Swing shelf bracket bottom tab into tower slot.
4. Place the shelf bracket notch onto bottom of tower
slot.
1. Lift shelf bracket up to allow shelf bracket notch
to clear the bottom of slot in tower.
2. Swing shelf bracket bottom tab out of slot in tower.
3. Drop shelf bracket down to allow shelf bracket top
hook to clear the slot in tower.
4. Remove shelf bracket top from slot in tower.
