Page 19 of 40
(10)
SECURITY NIGHT CURTAIN (OPTION)
SECURITY NIGHT COVER
LOCK HANDLE
SECURITY NIGHT COVER
FRONT HANDLE
SECURITY NIGHT
COVER LOCK
HANDLE CATCH
FRONT TRIM
BOTTOM FLANGE
TOP FLANGE
TOP PANEL
REMOVAL:
1.
Unlock the lock handle and turn handle to disengage from lock handle catch.
2.
Grab the lock handle and the front handle and lift the cover straight up out of the case opening.
INSTALLATION:
1.
Turn the lock handle so the latch is horizontal to the top of the case.
2.
Holding the lock handle and the front handle place the bottom flange of the security night cover inside
of case opening. The bottom flange of the security night cover must be tight against the flat inner side
of the front trim.
3.
Set the top flange of the security cover down against the top panel.
4.
Turn the lock handle so it engages the lock handle catch and use key to lock it in place.
Note:
The 6’ models have (2) security covers.
IMPORTANT
: Cleaning the Acrylic plastic security night cover require special care to prevent hazing of
material. Lightly dust (not wipe) the surface with clean soft cloth. Then the surface can be wiped carefully with
a soft, wet cloth or chamois. The cloth or chamois must be kept free of grit by frequently rinsing in clean
water. Grease and oil can be removed with kerosene. Do not use window cleaners or kitchen scouring
compounds. DO NOT use solvents such as Acetone, Benzene, Carbon Tetrachloride, and Lacquer Thinners. A
spray wax such as Pledge or Maguire’s polish can be applied and wiped with a clean soft
cloth. The wax tends
to fill in and hide small scratches.