Page 21 of 40
11.2
USING THE ELECTRONIC CONTROL
POWER TOGGLE & SET POINT UP ADJUST
MANUAL DEFROST AND SET POINT DOWN ADJUST
SET POINT ADJUST MODE
DIGITAL DISPLAY
11.2.1
Button and Display Overview
Press and hold this button for 3s to turn system on (if off) or off (if on).
Also used to adjust set point when in set point adjust mode
Press to enter set point adjust mode, confirm set point changes, and mute alarms.
Press and hold this button for 3 seconds to initiate a manual defrost (and cancel defrost if
initiated), also adjusts set point down when in set point adjust mode
+
Press both buttons simultaneously to check air stream probe temperature.
This is not an
indicator of product temperature.
11.2.2
Powering on control
To turn power on to the refrigeration system press and hold, for three seconds, the blue up arrow on
the control’s keypad. The keypad will read “On” while the button is depressed. When the system
power
s on, the display will read the current set point (a number “1” through “9”).
The orange
compressor run indicator will illuminate on the display.