Page 9 of 40
FRONT JOINING
BRACKET
REAR JOINING TRIM
CENTER PANEL
BASE MOUNTING
HOLES (4)
RIGHT CASE
LEFT CASE
LEFT CASE REAR
BASE PANEL
LEFT CASE FRONT
BASE PANEL
TOP JOINING
BRACKET
INTERIOR JOINING FLANGE
1.
Place the right case into desired location and level case by adjusting leg levelers with provided
wrench.
2.
Remove the front base panel (4) screws and rear base panels (6) screws from the left case. Push
the left case end tightly against the right case end. The rear joining trim on the right case must be
behind the back panel of the left case and the front joining bracket on the right case must be inside
the front aluminum trim channel of the left case.
3.
Adjust the leg levelers on the left case so it is level and exactly aligned with the right case. The (4)
base mounting hole in the right case panel must align with the (4) mounting holes located in base
compartment of left case.
4.
Push the cases together as tightly as possible and the gap between the cases must be tight and
even. If the gap is larger at the top or the bottom adjust leg levelers accordingly. HOLD CASES
TOGETHER AS TIGHT AS POSSIBLE WHILE ATTACHING ALL JOINING BRACKETS AND DO NOT OVER
TIGHTEN SCREWS OR SCREWS WILL STRIP OUT.
5.
Attach the bottom of the left case to the right case center panel base mounting holes through the
holes located inside of the left case base. Use the (4) large 10-12x1/2 screws provided.
6.
Attach the rear top of left case through the holes in the rear joining bracket using the (3) black
#10-12x1/2 self drilling screws provided.
7.
Attach the front of left case through the holes in the front joining bracket using the (2) smaller
#8-12x1/2 self drilling screws provided.
8.
Attach the top of left case through the holes in the top joining bracket using the (2) smaller
#8-12x1/2 self drilling screws provided.
9.
Attach the interior of left case through the holes in the interior joining flange using the (3) smaller
#8-12x1/2 self drilling screws provided
10.
If any there are any gaps along the joining seam fill them with NSF black silicone.
11.
Reinstall front and rear grills.
