Federal SN48, Installation & Operation Instructions

Series ’90 Non-Refrigerated Bakery

Page 5

PRE-INSTALLATION PROCEDURES

 
Inspection for Shipping Damage 

You are responsible for filing all freight claims with the delivering truck line.  Inspect all cartons 
and crates for damage as soon as they arrive.  If damage is noted to shipping crates or cartons or if 
a shortage is found, not this on the bill of lading (all copies) prior to signing. 

If damage is discovered when the case is uncrated, immediately call the delivering truck line and 
follow up the call with a written report indicating concealed damage to your shipment.  Ask for an 
immediate inspection of your concealed damage item.  Crating material must be retained to show 
the inspector from the truck line. 

INSTALLATION INSTRUCTIONS

 
Removing Case from Shipping Skid 

Move the case as near as possible to the final location before removing it from the shipping skid. 

Remove the four (4) bolts that secure the case to the skid. 

DO NOT REMOVE THE SHIPPING BRACKETS FROM THE CASE.  THE BRACKETS ARE 
INTENDED TO BE USED AS HAND GRIPS FOR LOCATING THE CASE.  REMOVE THE 
BRACKETS WHEN THE CASE IS IN THE FINAL LOCATION. 

Removing Packaging Material 

Remove the brackets that held the case to the shipping skid. 

Remove the plastic ties that hold the wire shelves and shelf brackets in place.  Remove the shipping 
tape that secures the doors and lift-up glass.  If it is necessary to remove tape residue from plastic 
materials, use cleaning compounds recommended in the cleaning section of this manual. 

Leveling the Case 

Four leg levelers are provided for leveling the case.  The leg levelers can be turned in and the case 
can be placed with the base frame on the floor. 

The leveled case should be sealed to the floor using an NSF Listed Sealant. 

CAUTION: 

Do not push against the curved glass, end glass, doors or door frames 

when removing the case from the skid or moving the case.  Case 
damage or glass breakage could result.