Floor surface around case may become slippery.
Excess condensation can occur and run onto the
floor if case is operated in an environment
above recommended temperature and humidity
levels.
Case is designed to operate in an environment
not to exceed 75º F.
This label is located on the back of the display case.
PRE-INSTALLATION PROCEDURES
Inspection For Shipping Damage
You are responsible for filing all freight claims with the delivering truck line. Inspect all
cartons and crates for damage as soon as they arrive. If damage is noted to shipping
crates or cartons, or if a shortage is found, note this on the bill of lading (all copies) prior
to signing.
If damage is discovered when the case is uncrated, immediately call the delivering truck
line and follow-up the call with a written report indicating concealed damage to your
shipment. Ask for an immediate inspection of your concealed damage item. Crating
material must be retained to show the inspector from the truck line.
INSTALLATION INSTRUCTIONS
Locating The Display Case
The case should be located where it is not subjected to the direct rays of the sun,
heating ducts, grills, radiator, or ceiling fans, nor should it be located near open doors or
main door entrances. Also, avoid locations where there is excessive air movement or
air disturbances.
The condenser air inlet is located at the rear of the case. Do not block this inlet and do
not locate the air inlet near a source of heat.
Removing Case from Shipping Skid
Move the case as near as possible to the final location before removing it from the
shipping skid.
Remove the eight (8) screws that secure the case to the skid.
Market Deli Refrigerated Cases
Page 3
CAUTION
:
Do not push against the curved glass, end glass, doors, or
doorframes when removing the case from the skid or moving
the case. Case damage or glass breakage could result.
