OPERATING INSTRUCTIONS
Initial Start-Up
After all the checks outlined in the installation section of this manual have been made,
the case is ready to be put into service.
Doors
Clean the door track frequently for easy door operation. A very light film of lubricant,
such as PAM, will help the doors slide easily.
The entire door track assembly may be removed if desired by tilting the top back and
lifting the entire frame out.
The display case is intended to be operated with the rear doors in place. However,
during peak service periods, the doors may be removed for ease of serving out of case.
DO NOT keep doors off unit for long periods of time.
Light Replacement
Remove bulb from top light assembly by rotating bulb 90 degrees and pulling outward.
This will allow bulb prongs to easily slide out of bulb receptacles located at each end of
the bulb.
The bulbs are furnished with plastic safety light shields. Make certain the light shields
are always in place to safeguard against bulb breakage.
When replacing lights, use direct equivalents to the original bulbs.
Placing Product into Case
Do not block the slots along the front or rear of the case display floor.
CASE SHOULD BE STOCKED WITH PRE-CHILLED PRODUCT ONLY.
The display pans are removable for cleaning and can become dislodged in shipment.
To ensure proper airflow and performance of the case, make sure that the display pans
are positioned as shown. Check that the pans are installed properly before placing
product on the display pans.
Market Deli Refrigerated Cases
Page 6
