Installer and Home Owner Section
Linear Steam Head
6
®
®
NOTE:
Drawings are for illustrative purposes only.
Consult with qualified designer, architect or contractor for steam room construction.
Model 104495
The Linear SteamHead is supplied with an optional steam diverter. The steam diverter is used to reduce the
steam emission zone as required to avoid contact between a steam bather and direct steam emissions
Always use the diverter if any steam bather may come into contact with direct steam
emissions. Contact MrSteam if a placement diverter is required. Failure to use a diverter to reduce the steam
emission zone as required to avoid contact between a steam bather and direct steam emissions may cause
personal injury.
Because direct steam is very hot, the diverter will be hot during the steam session, and will
remain hot for a period of time after steam session. Never install, remove or adjust a diverter when the steam
head is hot or if steam generator is turned on. Installing, removing or adjusting when the steam head is hot
or if the steam generator is turned on may cause a burn hazard and personal injury.
STEP 1.
Securely press Faceplate into the opening of Linear Steam Head. (see Fig. 7).
Diverter
Diverter
Figure 7
