FY2100S User’s Manual
Feel
T
e
c
h
Main output of waveform is SINE.
Main output of waveform if SQUR.
Main output of waveform is TRGL.
5. The “DUTY” means duty cycle, SQUR adjusted from 1% to 99%, while TRGL
adjusted among 50% (standard TRGL), above 50% and below 50% (both are different
saw tooth waves). SIN is disabled in this case.
:
(WAVE=SQUR)
:
(WAVE=SQUR)
:
(WAVE=TRGL)
:
(WAVE=TRGL)
:
(WAVE=TRGL)
6. COUNTER is counter function, and the counter values displayed on the
screen, impulse inputted from Ext.Input, reset to
“
0
”
as
“
OK
”
pressed and
counting again.
7. EXT.FREQ is exterior frequency measuring function, which can measure the
frequency of input signal.
8. SAVE can save the value of the current frequency, wave and duty, and there
are 20 storage position from M00 to M19, which adjusted by code switch, as
setting finished, then press
“
OK
”
button, when
“
OK
”
appeared on the screen,
