FEHN ASSEMBLY INSTRUCTIONS
CONTINUED
D
FEHN ASSEMBLY INSTRUCTIONS
CONTINUED
Step 3:
Step 2:
brass piston
seat tube
•
Unfold the Seat Tube and Brass Piston. Place the Ball End of the Brass Piston into the
Piston Lock Pocket on the base.
•
Pull down on the Seat Tube until the Brass Piston Ball End is securely locked into the
Piston Lock Pocket. You will hear a loud click when it locks securely.
•
Caution:
Do Not sit on the Fehn unless you are certain that the bottom of the Brass
Piston is securely locked into the Piston Lock Pocket.
•
(If you later need to fold the Fehn up for transport, use the Pull Pin to release the
Brass Piston from the Piston Lock Pocket)
piston lock pocket
pull pin
foot rest tube
•
Unfold the Foot Rest Tube until the slot at bottom fits over the threaded post on the base.
•
Screw the Knob (D) onto the post until it is firmly tightened against the base. You should not
be able to fold the Foot Rest Tube when it is installed properly.
threaded post
brass piston
ball end
FEHN ASSEMBLY INSTRUCTIONS
CONTINUED
FEHN ASSEMBLY INSTRUCTIONS
CONTINUED
Step 4:
seat mount block
F
G
H
I
J
•
Install the Seat (E) into the Seat Mount Block placing the washers in the order dipicted
above. The Bronze Washers (G) should be placed above the Seat Mount Block. The Belleville
Cone Washer (H) should be driectly below the Seat Mount Block with the high point of the
cone facing down. The Stainlees Steel Washer (I) should be placed below the Belleville Cone
Washer.
•
Use the 9/16” Wrench (J) to tighten the 3/8” Bolt (F) securely into the hole underneath the
Seat Mount Block.
E
Belleville Washer (H)
installed with cone
facing down
3
4
Please read the complete Warning on page 1 of
this manual carefully before using the FEHN.
IMPORTANT:
Before using the FEHN follow the Setup
Instructions on the following pages or watch the video at
www.TheFehn.com/setup to ensure the chair
is adjusted properly for your comfort and body!
