6. CHANGE ATTACHMENTS
If what you bought is multi-function sweeper & snow thrower, you should change the
function by yourself. Please check below steps for success assembly work.
To Separate Engine part and Attachments (Sweeper / Snow thrower head)
1. If the attachment on the machine is sweeper, please do following first:
a) Pull the hook (fig.11 A) upward to release the direction bar;
b) Pull the direction bar (fig.11 C) out from the hole.
c) Click the direction bar (fig.11 C) into hook (fig.11 B) to avoid its moving.
If the attachment on the machine is snow thrower, please skip this step.
2. Grasp the red lock control lever under left handle. Raise up the engine part to release
attachment (fig.12).
To Connect Engine part with Attachments (Sweeper / Snow thrower head)
1. Put the sweeper / snow thrower head on an open area.
2. If you are going to connect sweeper head, please make sure that both caster wheels
(fig.13A)
are in fifth groove.
15
