GB
14
1. Using the Allen wrench to make the two M8
×
16 screws through the two washer8 and the
mounting hole for left side support plate, then tighten the screw holes corresponding to the bent
legs( fig. 1)
Fig.1
2
、
Push the three M8
×
16 screws through the three washer8 and the mounting hole, then tighten the
screw holes corresponding to the bent legs. Push the four M8
×
16 bolts through the mounting hole of
the connecting plate and the support plate, then tighten with four M8 nuts. (Fig.2)
Fig.2
3
、
Connect the back cover, protection guard and support plate with M8
×
16 bolt and M8 nut. (Fig. 3)
Fig. 3
