2. Turn the protective guard so that uncovered part of the disc is as far apart as possible from the hand on
main handle (3).
3. Fix the protection guard by pushing the lock lever inwards (the protective guard should no longer be able
to move).
NOTE:
If the protective guard can not be fixed firmly by the lock lever (1), use a hexagon wrench to
tighten the hexagon nut.
6.6 REPLACING THE GRINDING DISC (FIG. 4
– 5)
Beware
– a disc which has been used may be very hot!
◼
Depress and hold down the spindle lock button (2) to secure the spindle.
◼
Turn the shaft until it locks.
◼
Remove the outer flange (a) and backing flange (b) by using the two-hole spanner provided.
◼
Fit the desired disc (8) on the spindle and replace the outer flange and backing flange. Release the
spindle lock.
Important! Only ever press the spindle lock when the motor and grinding spindle are at a
standstill!
You must keep the spindle lock pressed while you change the wheel !
For grinding wheels up to approx. 3 mm thick, screw on the flange nut with the flat side facing the grinding
wheel.
6.7 SWITCHING ON / OFF (FIG. 6)
Before engage the ON/OFF switch button, check that the grinding disc is properly fitted and
run smoothly, the outer flange is well tightened.
◼
Connect the battery pack onto the angle grinder body.
◼
To switch on the angle grinder, push the On/Off switch(4) to the right a little and then forward to catch
the lock-fixed slot.
◼
When you press the switch
“O”, the tool returns off.
◼
Do not let go of grinder until it has stopped running.
6.8 SPEED ADJUSTMENT
◼
This tools with 6 positions for speed adjustment, max speed 8500/min, you can choose the speed what
you want.
The wheel continues to rotate after the tool is switched off.
6.9 OPERATON MODES
Grinding
Hold the handle (3) and auxiliary handle (6) firmly and switch on. Avoid blocking the ventilation slots with
your hand, as this may cause the grinder to overheat. Let the disc reach full speed. Apply the grinder to the
13
