4/ When working at a high level, always make sure that no person or persons are below
you, as this could invite injuries to those persons under you.
5/ Before starting any job like breaking, chipping a wall, floor or ceiling, thoroughly
confirm that no items such as an electric cable, water pipe or conduit are buried inside as
this could cause injury or flooding.
6/ Properly set the bit holder.
7/ The bit can become very hot during operation exercise extreme caution as this could
cause injury.
8/ Always wear protective safety glasses.
9/ Always wear ear defenders or earplugs.
10/ Always wear suitable dust mask.
11/ Always wear protective footwear.
12/ Always wear hardhat.
Using the hammer
-
Place the bit you are going to use to do the job
-
Push the trigger switch after applying the chisel bit tip to the chiseling position.
-
It may be necessary to punch the bit against the crushing position forcibly in order to
begin the striking stroke.
-
By utilizing the weight of the machine and by firmly holding the hammer chisel with
both hands, one can effectively control the subsequent recoil motion.
-
Proceed at a moderate work rate, the use of too much force will impair efficiency.
09
