Declaration of the
vibration emission
values
Hammer drill mode
a
h,HD
=10,661m/s
2
Chiseling mode
a
h,CHeq
=12,269m/s
2
Uncertainty K
K=1,5 m/s
2
INFORMATION
The declared vibration total value has been measured in accordance with a standard test method
and may be used for comparing one tool with another;
The declared vibration total value may also be used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power tool can differ from the declared total value
depending on the ways in which the tool is used.
Need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as
the times when the tool is switched off and when it is running idle in addition to the trigger time).
Wear hearing protection.
4. USE
Assembly
Before any work on the power tool itself, pull the mains plug.
Auxiliary handle
Operate your power tool only with the auxiliary handle
Rotating the auxiliary Handle
The auxiliary handle can be set to any position for a secure and low-fatigue working posture.
Turn the bottom part of the auxiliary handle in counterclockwise direction and swivel the auxiliary
handle to the desired position. Then retighten the bottom part of the auxiliary handle by turning in
clockwise direction.
Pay attention that the clamping band of the auxiliary handle is positioned in the groove on the
housing as intended for.
Adjusting the drilling depth
The required drilling depth can be set with the depth stop.
Press the button for depth stop adjustment and insert the depth stop into the auxiliary handle.
The knurled surface of the depth stop must face downward.
Insert the SDS-PLUS drilling tool to the stop into the SDS-plus tools holder 3.Otherwise.the
movability of the SDS-plus drilling tool can lead to incorrect adjustment of the drilling depth.
Pull out the depth stop until the distance between the tip of the drill bit and the tip of the depth stop
correspond with the desired drilling depth.
Selecting drill chucks and Tools
For hammer drilling and chiseling ,SDS-plus tolls are required that inserted in the SDS-plus drill
chuck .For drilling without impact in wood, metal ,ceramic and plastic as well as foe screwdriving
and thread cutting, tools without SDS-plus are used (e.g. drills with cylindrical shank ).
06
