Position for
hammer drilling
in concrete or stone
Position for
drilling
without impact in wood, metal, ceramic and plastic as well as for screwdriving and
thread cutting
Vario-Lock
position for adjustment of the chiseling position
The mode selector switch does not latch in this position.
Position for
chiseling
Reversing the Rotational Direction
The rotational direction switch is used to reverse the rotational direction of the machine. However, this is not possible with
the On/Off switch actuated.
Right rotation
: Turn the selector switch for drilling/hammer drilling on both sides to the stop in the position
R
.
Left rotation:
Turn the selector switch for drilling/hammer drilling on both sides to the stop in the position
L
.
Set the direction of rotation for hammer drilling, drilling and chiseling always to right rotation.
Switching On and Off
To star the machine, press the On/Off switch.
To lock the On/Off switch, keep it pressed and additionally push the lock-on button.
To switch off the machine, release the On/Off switch. When the On/Off switch is locked, press it first and then release it.
Setting the Speed/Impact Rate
The speed/impact rate of the switched on power tool can be variably adjusted, depending on how far the On/Off switch is
pressed.
Light pressure on the On/Off switch results in low speed/impact rate. Further pressure on the switch increases the
speed/impact rate.
Summary of Contents for FMP800
Page 11: ......
