Overload Clutch
If the tool insert becomes caught or jammed, the drive to the drill spindle is interrupted. Because of the forces that occur
always hold the power tool firmly with both hands and provide for a secure stance.
If the power tool jams, switch the machine off and loosen the tool insert. When switching the power tool on with the drilling
tool jammed, high reaction torques can occur.
Working Instructions
The chisel can be locked in 36 positions. In this manner, the optimum working position can be set for each application.
Insert the chisel into the tool holder.
Turn the mode selector switch to the “Vario-lock” position (See “setting the operating mode”). Turn the tool holder to the
desired chiseling position.
Turn the mode selector switch to the chiseling position, the tool holder is now locked.
For chiseling, set the rotation direction to right rotation.
Inserting screwdriver bits
Apply the power tools to the screw/nut only when it is switched off .Rotating tool inserts can slip off.
To work with screwdriver bits, a universal bit holder with SDS-plus shank (accessory) is required.
Clean the shank end of the adapter shank and apply a light coat of grease.
Insert the universal bit holder with a turning motion into the tool holder until it automatically locks.
Check the locking effect by pulling the universal bit holder.
Insert a screwdriver bit into the universal bit holder. Use only screwdriver bits that match the screw head.
To remove the universal bit holder, pull the locking sleeve 6 toward the rear and remove the universal bit holder 15 out of
the tool holder.
Maintenance and cleaning
Before any work on the power tool itself, pull the mains plug.
For safe and proper working, always keep the power tolls and the ventilation slots clean.
A damaged dust protection cap should be changed immediately. We recommend having this carried out by after-sales
service.
If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its
service agent.
Others maintenance and inspection shall be provided by a service agent.
Summary of Contents for FMP800
Page 11: ......
