12
Lift the sander off the work before switching off. Remember to keep your hands
away from the moving belt, as it will continue to move for a short time after the
machine is switched off.
If there are still scratches on your work after sanding, try either of the following:
-Go back to a coarser grit and sand the marks out before recommencing with the
original choice or,
-Try using new sanding belt of the same grit to eliminate the unwanted marks before
progressing to a finer grit and finishing the job.
6.
SERVICE & MAINTENANCE
Always disconnect the device before performing any adjustment or
maintenance operation.
If the supply cord of this power tool is damaged, it must
be replaced by a specially prepared supply cord available through the service
organization.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
If the carbon brushes need to be replaced, have this done by a qualified repair
person (always replace the two brushes at the same time)
Cleaning
Avoid using solvents when cleaning plastic parts. Most plastic parts are
susceptible to damage from various types of commercial solvents and may be
damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
Lubrication
All the bearings in this tool are lubricated with a sufficient amount of high grade
lubricant for the life of the unit under normal operating conditions, therefore no
further lubrication is required.
