In case of accident, immediately stop using the machine. Turn the machine off and check
the problem. Do not use the machine while the machine is damaged.
If the machine should start making any unusual noise or vibration, immediately shut off the
power source and allow the machine to stop. Take the following steps before restarting and
operating the machine:
a) Inspect for damage;
b) Replace or repair any damaged parts;
c) Check for and tighten any loose parts.
If the machine becomes clogged, shut-off the power source before cleaning debris.
Never operate the machine with defective guards or shields, or without safety devices in
place.
Keep the power source clean of debris and other accumulations to prevent damage to the
power source or possible fire.
Do not carry this machine while it is in operation. Always switch off the tool and always
transport it by its handle and in order to avoid accidents and a fuel leak.
Stop the machine and make sure that all moving parts have come to a complete stop
a) Whenever you leave the machine;
b) Before clearing blockages or unclogging chute;
c) Before checking, cleaning or working on the machine.
Do not tilt the machine while the power source is running.
Operate the machine at the lowest possible engine speed to do the job. Like this, vibration
and noise levels as well as the tool’s wear can be kept to a minimum.
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces.
Use the full blower nozzle extension so the air stream can work close to the ground.
Watch out for children, pets, open windows etc. and blow debris safety away.
WARNING: DO NOT USE ANY OTHER FUEL than that recommended in your manual.
Always follow instructions in the Fuel and Lubrication section of this manual. Never use
gasoline unless it is properly mixed with 2-cycle engine lubricant. Permanent damage to
engine will result, voiding manufacturer’s warranty.
DO NOT SMOKE while refueling or operating equipment.
DO NOT OPERATE UNIT WITHOUT A MUFFLER and properly installed muffler shield.
DO NOT TOUCH or let your hands or body come in contact with a hot muffler or spark plug
wire.
DUE TO THE DANGER of exhaust fumes, never operate blower in a confined or poorly
ventilated area.
NEVER POINT BLOWER in the direction of people, animals, buildings, automobiles, or
open windows, etc.
DO NOT operate unit without inlet cover installed to prevent contact with impeller.
DO NOT set a hot engine down where flammable material is present.
DO NOT OPERATE UNIT FOR PROLONGED PERIODS. Rest periodically to prevent
damage from vibration, damage to ears or damage to the appliance.
Operate the machine in a recommended position and only on a firm, level surface.
Do not operate the machine on a paved or gravel surface where ejected material could
cause injury.
WARNING: DO NOT ADD, REMOVE OR ALTER ANY COMPONENTS OF THIS PRODUCT.
Doing so could cause personal injury and/or damage the unit, voiding the
manufacturer’s warranty.
DO NOT OPERATE UNIT WHILE TIRED, SICK OR UNDER THE INFLUENCE OF
ALCOHOL OR DRUGS.
DO NOT operate your unit near or around flammable liquids or gases whether in or out of
doors. An explosion and/or fire may result.
DO NOT WEAR loose clothing, scarfs, neck chains, unconfined long hair, and the like.
4
Summary of Contents for FSDT75
Page 25: ...NOTES 25 ...
Page 26: ...NOTES 26 ...
Page 27: ...NOTES 27 ...
Page 28: ...BUILDER SAS 32 rue Aristide Bergès ZI 31270 Cugnaux France Made in PRC 2021 ...