10
d. Installing bits
-
Put the reverse/forward on the center position.
-
Slide the bit grip forward and hold in position (1).
-
Insert the bit straight into bit grip (2).
-
Slide the bit grip back slowly and release.
-
Make sure that the bit is well installed in place. Failure when installation will create
accidents and injuries
e. Removing the bits
-
Switch off the tool and put the reverse/forward switch in the center position.
-
Slide the bit grip forward and hold in position.
-
Pull the bit straight out of the coupler.
f. Installing belt clip
-
Put the reverse/forward switch in the center position
-
To reduce the risk of serious personal injury, do not suspend tool overhead or
suspend objects from the belt hook. Only hang the tool’s belt clip from a work belt.
-
When attaching or replacing the belt clip, use only the screw that is provided. Be sure
to securely tighten the screw.
-
The belt clip can be attached either side of the tool using only the screw provided, to
accommodate left or right handed users.
-
To move belt clip, remove the screw that holds the belt clip place then reassemble on
the opposite side. Be sure to securely tighten the screw.
NOTE: Belt clip is not provided with this tool
