1) Loosen and remove flower pan head screw M6 x 12 (22). Remove the cutter head adjustment handle
(1).
2) Remove four hexagon socket flat head screws (36) from the top panel (37) of the planer.
3) Lift the side panel (38) (located on the cutter head adjustment handle side) up out of the slot in the
base and remove the side panel (38) from the machine.
4) Cut off the old timing belt (39) with scissors (42) (not supplied) and remove it.
5) Start a new timing belt (39) on the top pulley (40) with the grooves on the top pulley, as shown in
Fig.Y3.
6) Guide the belt to the lower pulley (41); with grooves engaged on the lower pulley, rotate the lower
pulley clockwise. Keep pressure on the edge of the belt to keep the grooves engaged on the top pulley.
7) Continue pressure on the side of the belt and rotate the lower pulley while hopping the belt further onto
the pulleys.
8) All the belt grooves should be engaged in the final position shown in Fig. Y4 and the pulleys should
rotate smoothly.
9) Replace the belt cover, side panel and top panel. Do not overtighten the screws.
NOTE:
No tools are necessary to install a belt. The use of a screwdriver or other tool to pry or stretch a belt may
cause damage to the pulleys and ultimately destroy the new belt.
7.7 TO REMOVE BRUSH ASSEMBLY (FIG. X)
WARNING:
To reduce the risk of serious
personal injury, turn tool off and disconnect tool
from power source before making any adjustments
or removing/installing attachments or accessories.
1)
Remove the brush inspection cap (35).
2)
Withdraw the brush assembly.
20
