IDENTIFICATION
ID HyWEAR compact
7 Components
Page 16 of 41
7 Components
Components
7.1 Electrical
7.1.1 Battery
The rechargeable battery for the ID HyWEAR compact is a LiPo battery.
WARNING:
To reduce the risk of fire, explosion and burns:
Do not crush, puncture, short circuit the battery or place it in fire or water!
Do not attempt to open, disassemble or service the battery!
Only charge the battery with the ID HyWEAR Charging Station!
Do not deep discharge the battery!
Do not use damaged batteries!
Do not expose the battery to temperatures above 60 °C (140 °F)!
Do not charge the battery below 0 °C (32 °F)!
7.1.2 Scanner Unit
The electronics of the scanner unit are protected by the housing and must not be disassembled.
7.2 Mechanical
7.2.1 Fingerless Glove
The fingerless glove is made of textile and therefore is durable but still comfortable to wear. The fingerless
glove can be adjusted using the Velcro strips on the wrist and index finger. The scanner unit is slid into the
provided pocket and fixed by means of a Velcro strip. Ensure that the contacts are connected propery.
7.2.2 Housing
The housing is made of robust ABS and is IP54 classified.
7.3 Optical
7.3.1 Laser
The installed laser for reading 1D and 2D barcodes is a class 2 laser. The laser has a power of
≤ 1 mW. The
wavelength is 663 nm.
WARNING:
To prevent damage through laser light:
Do not attempt to open, disassemble or service the laser or the housing!
Do not stare directly into the laser beam!
Avoid that the laser hits the eye of an observer, even through reflective surfaces like mirrors, etc.
