IDENTIFICATION
Installation
ID ISC.ANT1520/680-A/-B
FEIG ELECTRONIC GmbH
Page 36 of 82
ID ISC.ANT1520680-A-B User
Manual_M61112-1e-ID-E-
060317.doc
Afterwards set the operating power, Transponder Parameters and ISO Host Mode:
Step
Action
Note
1
Select “Configuration”
2
Air Interface:
“Output -Power” = 8W
„Multiplexer Enable“
„1 Input (Single Mode)“
„No of Output Channels „
(e.g. 2)
„Antenna Active Time“
100 x 5ms
“Receiver Channel” Upper
and Lower Sideband
3
Set by clicking on „Apply“.
4
Transponder:
Configure the parameters as
following:
•
„Driver“ – here ISO 15693
•
„Anticollision“ – enable
•
„No of Timeslots“ –
1 timeslot
•
„Data Coding“ – 1 of 4
•
„AFI“ – Disabled
Note: National RF regulations may require different
settings.
8 Configure the reader in accordance with
national RF regulations
5
Set by clicking on „Apply“.
