IDENTIFICATION
Installation
ID ISC.ANT1520/680-A/-B
FEIG ELECTRONIC GmbH
Page 66 of 82
ID ISC.ANT1520680-A-B User
Manual_M61112-1e-ID-E-
060317.doc
„True“ means: LED with
Bus Address 11, 12, ... 17
will be active if the reader
read a valid transponder on
the corresponding antenna
7
Set by clicking on „Apply“.
8
The sensitivity of the
connected radar modules
could be set by
- Peripheral Device
Commands, section,
- People Counter at
Busaddress 1,2 and 3
- Byte 11:
00 = Low
05 = Middle
0A = High
0F = Very high
First “Read” out actual
setting of sensitivity.
If needed change to new
sensitivity by “Write” the
new value into the GPC.
A “People Counter Reset”
command must be sent to
confirm the change,
otherwise the sensitivity will
not change.
Test: People Counter
9
Select „Commands“
10
Select Command
- „Get Reader Info“
- Peripheral Devices
1
.
2
.
