OBID
i-scan
®
UHF
Manual
ID ISC.MU02.02
FEIG ELECTRONIC GmbH
Page 91 of 96
H90701-3e-ID-B
ANNEX C: Index of Status Bytes
Hex-value
Transponder Status
0x00
OK:
•
Data / parameters have been read or stored without error
•
Control command has been executed
0x01
No Transponder:
•
No Transponder is located within the detection field of the Reader.
•
The Transponder in the detection field has been switched to mute .
•
The communication between Reader and Transponder has been interfered and the Reader is not
able to read the Transponder anymore.
0x02
Data False:
•
CRC16 data error on received data.
0x03
Write-Error:
Negative plausibility check of the written data:
•
Attempt to write on a read-only area
•
Too much distance between Transponder and Reader antenna.
•
Attempt to write in a noisy area.
0x04
Address-Error:
The required data are outside of the logical or physical Transponder-address area:
•
The address is beyond the max. address space of the Transponder.
•
The address is beyond the configured address space of the Transponder.
0x05
Wrong Transponder-type:
This command is not applicable at the Transponder:
•
A special command is not applicable to the Transponder.
0X08
Authent Error
•
If access password is wrong
0x10
EEPROM-Failure:
•
The EEPROM of the Reader is not able to be written on.
•
Before writing onto the EEPROM a faulty checksum of parameters has been detected.
0x11
Parameter-Range-Error:
•
The value range of the parameters was exceeded.
0x13
Login-Request:
•
Configuration access without having logged in to the Reader before.
0x14
Login-Error:
•
Login attempt with wrong password.
