OBID
®
Installation
ID RW02.10-AD/-B
FEIG ELECTRONIC GmbH
Page 25 of 31
E N G L I S H
NOTE:
The lead-in wire should not be laid directly parallel to other power supply- and low voltage
wires.
4.3 Relay
The device is equipped with an relay (normally open contact). The connection is executed via the
connectors [NO] and [COM].
4.4 Digital inputs (IN1 / IN2)
The digital inputs [IN1] and [IN2] can only be connected to internal GND (terminal [GND]) accord-
ing to Fig. 8 connection of the digital inputs
Any connection to external voltage might damage the unit!
Fig. 8 connection of the digital inputs
4.5 RS232 Interface (ID RWA02.10-A)
Fig. 9 connection of the RS232-interface
Host
R/A
T/B
GND
ID RW02
RxD
TxD
GND
IN1
IN2
GND
