OBID
i-scan
®
UHF
Installation
ID ISC.ANT.U170/170-FCC
FEIG ELECTRONIC GmbH
Page 7 of 12
M21014-2e-ID-B
3. Installation
The antenna is designed for wall or fixture mounting. Mounting holes are provided in the housing.
Please note that only these holes should be used when mounting the antenna.
An optional mounting set is available to simplify the attachment of the antenna to portal structures
or poles and can be ordered from FEIG ELECTRONIC GmbH.
The preferred mounting direction of the antenna is vertical, with the connection cable towards
ground.
Figure 1: Mounting drawing
CAUTION:
Bending radius of the connection cable: 14 mm (static) / 42 mm (dynamic)
All Dimensions ± 0,5 mm
