OBID
i
-scan
Installation
ID ISC.PRH100-A/-USB
FEIG ELECTRONIC GmbH
Page 22 von 31
M30200-0de-ID-B.doc
E N G L I S H
3. Assembly and wiring
The readers are designed for an office environment. They can be wall-mounted, in this case the
wall-mount kit should be ordered separately.
(see Appendix:
Accessories and Wall mounting kit ID ISC.MS.MR/PR-A)
Notes:
•
The distance between two readers of the same type should not fall below 4m.
•
Before any installation the intended position of the reader should be tested for its suit-
ability.
•
Only ID ISC.PR100:
The reader must not be installed directly upon conductive materials as e.g. metal sur-
faces, metal grids (reinforcements) or metallized surfaces, as these surfaces reduce the
detection range of the reader. The distance between the reader and such surfaces
should be min. 10 cm.
3.1. Connector
sockets
Fig.: 1: Connector sockets
Sockets
Description
X1
Power supply
X3
USB-plug
X4
Connection of the external antenna
(direct impedance 50
Ω
)
Table: 2: Connection sockets
X1
X3
X4
