OBID i-scan
®
System-Manual
ID ISC.MR/PR/PRH101
FEIG ELECTRONIC GmbH
Page 57 of 131
H60301-3e-ID-B.doc
6. Protocols for ISO15693 Host Commands
Some ISO15693Host commands can be used to access I-Code 1 Transponders. The additional com-
mands
Read Config Block
and
Write Config Block
were created by FEIG ELECTRONIC to provide
full Transponder configuration capabilities for I-Code 1 Transponders via the OBID
®
i
-scan
memory
model (see
ANNEX G: Memory Model I-Code 1 Transponders
). The following combinations are possi-
ble:
Transponder Types
I-Code 1
ISO15693
I-Code
EPC/UID
6.1. [0xB0] Host commands for ISO15693 Mandatory
and Optional Commands
√
√
√
6.1.1. [0x01] Inventory
√
√
√
6.1.2. [0x02] Stay Quiet
√
6.1.3. [0x22] Lock Multiple Blocks
√
√
1
6.1.4. [0x23] Read Multiple Blocks
√
√
6.1.5. [0x24] Write Multiple Blocks
√
√
√
6.1.6. [0x25] Select
√
6.1.7. [0x26] Reset to Ready
√
6.1.8. [0x27] Write AFI
√
6.1.9. [0x28] Lock AFI
√
6.1.10. [0x29] Write DSFI
√
6.1.11. [0x2A] Lock DSFI
√
6.1.12. [0x2B] Get System Information
√
6.1.13. [0x2C] Get Multiple Block Security Status
√
6.1.14. [0xA0] Read Config Block
√
2
6.1.15. [0xA1] Write Config Block
√
3
8. [0xB1] Host commands for ISO15693 Custom and
Proprietary Commands
√
8.6. [0xBF] ISO15693 Transparent Command
√
1
only Philips I-Code UID
2
3
Read and Write Config Block will only be available if the I-CODE_MODE (MAPPING)is set to “FEIG Memory
Model“ see:
3.5. CFG4: Transponder Parameters
