OBID i-scan
®
System-Manual
ID ISC.MR/PR/PRH101
FEIG ELECTRONIC GmbH
Page 92 of 131
H60301-3e-ID-B.doc
8.3.4. [0xA5] EAS Alarm
If the EAS bit is set to 1 the EAS response status 0x00 is returned from the transponder. This com-
mand is available in all modes (non-addressed , addressed and selected).Whether the reader receives
the sequence or not is shown to the host by setting the status byte.
REQUEST-DATA
5
6
(7-14)
0xA5
MODE
UID
RESPONSE-DATA (STATUS = {0x95})
5
ISO-ERROR
MODE:
Bit:
7
6
5
4
3
2
1
0
Function
-
-
-
-
-
ADR
ADR:
ADR
b000
non-addressed
b001
addressed
b010
selected
UID:
Read-only serial number of the transponder. The UID is required only in the addressed mode.
ISO-ERROR:
ISO error code of transponder response. This byte is only available if STATUS = {0x95}.
Note:
•
If an error is detected or the EAS bit is set to “0” the transponder remains silent and the
status 0x01 will be sent to the host.
•
If EAS bit is set to “1” the status will be 0x00.
