IDENTIFICATION
ID PM ECCO+
6 Operation
Page 14 of 24
6.4.2 1D/2D Imager
To scan a barcode follow the steps below:
1. Aim the scanner on the barcode.
2. Press the trigger key (5).
3. The ID PM ECCO+ decodes the barcode closest to the cross center unless you disable the Pick-List
Mode (see below) in the 2D cameras.
4. The device beeps and the yellow LED (2) lights up yellow to indicate a successful decode.
6.4.3 RFID
To scan an RFID tag follow the steps below:
1. Aim the scanner on the RFID tag.
2. Make sure the tag is within the reader range.
3. Press the trigger key (5) to read data of the RFID tag.
4. The device beeps and the yellow LED (2) lights up to indicate a successful decode.
Fig. 3: Scan Example 1D/2D Imager
