1
2
3
FZ12 Microscope Assembly
6
Fein
Assemble the Microscope Body
Remove the decorative cover (1) of the focus
bracket. Loosen the M4 inner hexagon screw with a
M4 inner hexagon Allen key.
Match the dovetail interface (3) of the microscope
body with the dovetail groove (2) of the focus
bracket group, and insert it from top to bottom in
the direction as shown in the figure.
Tighten the M4 inner hexagon screw on the focus
bracket group with a M4 inner hexagon Allen key.
Replace the decorative cover (1).
Assemble the Objective
Attach the objective (2) into the bottom of the
microscope body (1) by rotating the objective until
objective is fully installed.
Assemble the Focusing Bracket
Loosen the lock knob (1) of the focusing bracket
group. Insert the hole (2) of focusing bracket group
into the column (3), until the focusing bracket group is
in the lowest position. Then tighten the lock knob (1)
to prevent the microscope from turning.
Ensure the focusing bracket is assembled
correctly to prevent the microscope from
tipping over.
1
2
3
2
1
