FZ12 Microscope Assembly
7
Fein
Assemble the Microscope Head
Loosen the head set screw (1) fully with a M4 inner
hexagon Allen key.
With the microscope head facing forward, insert the
bottom of the microscope head into the top hole
of the microscope body matching the orientation
groove (2) with the orientation pin (3) of the body.
Secure the microscope head to the microscope body
with the set screw.
Assemble the Eyepieces
Remove the eyepiece tube covers (1).
Insert the eyepieces (3) into the eyepiece
tube until the bottom of the eyepieces
touches the bottom of the eyepiece tube.
Secure the eyepieces with the set screws (2).
Assemble the Stage Plate
Place the stage plate into the well space on
the microscope stand.
To remove the stage plate, press down with
fingertips on one edge of the stage plate.
This will result in the other side of the stage
plate lifting, allowing it to be removed.
2
3
1
1
3
2
Assemble the Reticle
Unscrew the pressure ring from the eyepiece.
Clean the reticle, then install it into the
pressure ring with the scaled surface upward.
Screw the pressure ring with reticle into the
eyepiece until tight.
To remove the reticle, first unscrew the
pressure ring from eyepiece, then remove
the reticle.
Scaled Surface
Screw-in
Screw-out
