15
en
Selecting the rotation direction
(figure 5).
To avoid accidental starting, e. g., during
transport, set the rotation selector switch to
the centre position.
Set the Rotation selector switch to right or
left rotation as required.
Adjust the rotation selector switch only
when the machine is at a complete stop.
Setting the operating mode.
Change the operating mode only when the
power tool is switched off! Otherwise, the
machine can become damaged.
Always turn the operating mode selector
switch to the stop. Otherwise, the machine
can become damaged.
ASB 14/18 (figure 6)
Set the desired operating mode.
–
For
drilling
, set the operating mode selec-
tor switch to the “drilling” symbol.
–
For
screwdriving
, set the operating mode
selector switch to the “'screwdriving'”
symbol.
–
For
hammer drilling
, set the operating
mode selector switch to the “hammer
drilling” symbol.
ABS 14/18 (figure 7)
Set the desired operating mode.
–
For
drilling
, adjust the torque setting to the
“drilling” symbol.
Rotational direction switch
Fig. 5
Operating mode selector switch
Fig. 6
Torque setting
Fig. 7
OBJ_BUCH-0000000113-001.book Page 15 Wednesday, April 17, 2013 10:01 AM
