Repair instructions
6. Disassembly
1. Take off rubber ring.
2. Heat up gearbox housing (approx. 70 °C).
3. Attach extractor tool to motor.
When attaching the recesses in the extractor tool must be in line with the carbon holders in
When attaching, the recesses in the extractor tool must be in line with the carbon holders in
order to prevent damage to the carbon holders.
4. Tighten upper part of extractor tool.
5. Twist upper part of extractor tool against lower part and pull motor off gearbox head.
Tool:
-Extractor tool 6 41 14 033 000
-Hot air gun
All rights reserved by FEIN, especially in case of industrial rights registration.
FEIN retains all rights of disposal, such as copying and circulation.
C-SC_CSSM
2012.08
13/25