8
en
Never place your hand near the rotating
accessory.
Accessory may kickback over
your hand.
Do not position your body in the area where
power tool will move if kickback occurs.
Kick-
back will propel the tool in direction opposite
to the wheel’s movement at the point of snag-
ging.
After working gypsum-containing materials:
Blow out the ventilation openings of the
power tool and the switch element with dry
and oil-free compressed air.
Otherwise, gyp-
sum-containing dust can settle in the power
tool housing and switch element, which can
harden in connection with humidity. This can
impair the switching mechanism.
Use and handling of the battery
(battery pack)
To avoid hazardous situations such as burns,
fire, explosion, skin injuries, and other inju-
ries when handling the battery, observe the
following instructions:
Batteries must not be disassembled, opened
or reduced in size. Do not subject batteries to
mechanical impact or shock.
Hazardous
vapours and fluid can escape in case of dam-
age and improper use of the battery. The
vapours can irritate the respiratory system.
Liquid ejected from the battery may cause
skin irritations or burns.
When battery fluid from a damaged battery
has come into contact with objects close by,
check the respective components, clean them
or replace them as required.
Keep the battery away from heat and fire. Do
not store the battery in direct sunlight.
Do not remove the battery from its original
packaging until it is going to be used.
Before any work on the machine itself,
remove the battery from the power tool.
If the
power tool accidentally starts, there is danger
of injury.
Remove the battery only when the power tool
is switched off.
Keep the battery away from children.
Keep the battery clean and protect it against
moisture and water.
Clean contaminated bat-
tery terminals and power tool connections
with a dry, clean cloth.
Charge the batteries only with battery char-
gers recommended by the manufacturer.
A
charger that is suitable for one type of battery
may create a risk of fire when used with
another battery.
Keep the battery not being used away from
paper clips, coins, keys, nails, screws or other
small metal objects, that can make a connec-
tion from one terminal to another.
Shorting
the battery terminals together may cause
burns or a fire.
Remove the power tool's battery during trans-
port and storage.
Use only intact original FEIN batteries that are
intended for your power tool.
When working
with and charging incorrect, damaged,
repaired or reconditioned batteries, imita-
tions or other brands, there is danger of fire
and/or explosion.
Follow the safety warnings in the operating
instructions of the battery charger.
Handling hazardous dusts.
When working with power
tools, such as when grinding,
sanding, polishing, or for other work proce-
dures where material is removed, dusts
develop that are both hazardous to one's
health and can spontaneously combust or be
explosive.
Contact with or inhaling some dust types can
trigger allergic reactions to the operator or
bystanders and/or lead to respiratory infec-
tions, cancer, birth defects or other reproduc-
tive harm.
Examples of such materials which contain
chemicals that can produce hazardous dusts,
are:
–
Asbestos and materials containing asbes-
tos;
–
Lead-containing coatings, some wood
types such as beech and oak;
–
Minerals and metal;
–
Silicate particles from bricks, concrete and
other materials containing stone;
WARNING
OBJ_BUCH-0000000289-001.book Page 8 Wednesday, November 22, 2017 8:24 AM
