MVK 01/06
All rights reserved by FEIN, in particular as these apply to trademarks.
FEIN retains all powers of disposition such as copying and right of transfer
.
FRT: EVO WSB and WSG - Variants
43/118
5.1. Assembling gearbox case 1
1.
Image: Parts
2.
Place the gearbox case (405) backwards onto the support (arrow) of the
press-in tool (special tool).
3.
Insert the cam plate (440).
4.
Insert ondular washer (450).
5.
Insert the needle sleeve (460) with the correct position so that it is flush.
Warm up the gearbox case to 80-100°C.
The bearing labelling should not be visible when pressed in.
6.
Image: Bearing labelling
Tools:
•
Press-in tool
(special tool)
64114024005 or
metal block
15x30x25
•
Hot air dryer
•
Mandrel press
1.
2.
3.
4.
5.
6.