15
en
Starting and stopping the drill motor
(figure 9).
Starting:
Switch the motor switch ON.
Stopping:
Switch the motor switch OFF.
Shutting magnet OFF:
Switch off the magnet with the magnet power
switch.
Feed (figure 10).
Feed using the spoke handle.
Instructions for core drilling.
Do not stop the drill motor during the drilling
procedure.
Only remove the cutting tool from the hole
while the motor is running.
After each drilling operation, remove the
chips and the slug.
Do not touch the chips with your bare
hand. Always use a chip hook.
Chips are sharp and hot!
When core drilling layered
material, use a FEIN ID sharpened cutter for
stack drilling.
When core drilling layered material, remove
the core and the chips after having drilled
through each layer.
When changing a cutting tool, pay attention
not to damage the cutting edges.
CAUTION
OBJ_BUCH-0000000103-002.book Page 15 Thursday, July 24, 2014 11:49 AM
