KBM 65U, JCM 256U
All rights reserved by FEIN, especially in case of industrial rights registration.
FEIN retains all rights of disposal, such as copying and circulation.
C-SC_CSSM
2013.06
57/82
Version 1.0
1. Press both grooved ball bearings in to housing (1).
Place something underneath housing otherwise it will tip when the grooved ball bearings are
pressed in.
2. Apply thin layer of grease to the three sealing rings (2) and insert.
Do not assemble sealing rings with a sharp tool as this could damage them.
3. Press shaft and grooved ball bearings in to housing (3).
4. Secure shaft with a circlip (4).
7. Assembly
Assembling gearbox housing
Tool:
- Circlip pliers
- Arbor press
- Sleeve
outer: 21 mm
inner: ~10 mm
- Sleeve
outer: 28 mm
inner: ~21 mm
- Sleeve
outer: 53 mm
inner: 45 mm
- Base: Height: 66 mm
Width: ~20 mm
- Hook
- Grease (0 40 106 0100 1)
1
2
4
3
