10
en
Extension cable.
If the use of an extension cord
is required, its length and con-
ductor cross-section must be adequate for the
application in order to prevent a voltage drop
in the extension cord, power loss and over-
heating of the power tool.
Otherwise, the
extension cable and power tool are prone to
electrical danger, and the working efficiency is
decreased.
Recommended dimensions of extension
cables at an operating voltage of 120 V – sin-
gle-phase a. c., with only one power tool MSf,
MSfo, MSfov connected:
Intended use of the power tool:
Hand-guided straight grinder for dry grinding
of metal with small grinding accessories
(grinding points) and for grinding metal with
hard metal cutters in weather-protected envi-
ronments with the accessories recommended
by FEIN.
Symbols.
WARNING
Max. cable length, ft
Max. cable length, m
≤ 100
100
–200
200
–300
≤ 30
30
– 60
60
–100
Min. conductor size
A.W.G.
Min. conductorcross-
section, mm
2
16
14
12
1.5
2.5
4.0
Symbol, character
Explanation
General prohibition sign. This action is prohibited.
Do not touch the rotating parts of the power tool.
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Man-
ual and the General Safety Instructions.
Before commencing this working step, pull the power plug out of the
socket. Otherwise there will be danger of injury if the power tool
should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Use a dust mask during operation.
Use protective gloves during operation.
A surface that can be touched may be very hot and thus hazardous.
Gripping area
OBJ_BUCH-0000000343-001.book Page 10 Thursday, September 19, 2019 10:13 AM
