Fein MShy649-1 User Manual Download

Page: 19 / 96

For your safety.

Read all safety warnings and all instruc-
tions.

Failure to follow the warnings

and instructions may result in electric

shock, fire and/or serious injury.

Save all warnings and instructions for future reference.

Do not use this power tool before you have thor-
oughly read and completely understood this
Instruction Manual and the enclosed “General

Safety Instructions” (document number
3 41 30 054 06 1). The documents mentioned should be
kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial safety
regulations.

Intended use of the power tool:

hand-guided straight grinder for dry grinding of metal
with double-sided conical grinding wheels (form 4) in
weather-protected environments with the accessories
recommended by FEIN.

Safety warnings common for sanding, sanding with
sanding sheets, working with wire brushes,
polishing and cut-off grinding

This power tool is to be used as a grinder. Observe all safety
warnings, instructions, illustrations and data supplied with
the power tool.

Non-observance of the following instruc-

tions can lead to electric shock, fire and/or serious injury.

This power tool is not suitable for sanding with sanding
sheets, working with wire brushes, polishing and cut-off
grinding.

Applications, for which the power tool is not

intended for, can lead to hazardous situations and injury.

Do not use accessories which are not specifically designed
and recommended by the tool manufacturer.

Just because

the accessory can be attached to your power tool, it does
not assure safe operation.

The rated speed of the accessory must be at least equal to
the maximum speed marked on the power tool.

Accessories

running faster than their rated speed can break and fly
apart.

The outside diameter and the thickness of your accessory
must be within the capacity rating of your power tool.

Incorrectly sized accessories cannot be adequately
guarded or controlled.

The arbor size of wheels, flanges, backing pads or any other
accessory must properly fit the spindle of the power tool.

Accessories with arbor holes that do not match the
mounting hardware of the power tool will run out of bal-
ance, vibrate excessively and may cause loss of control.

Do not use a damaged accessory. Before each use inspect
the accessory such as abrasive wheels for chips and
cracks, backing pad for cracks, tear or excess wear, wire
brush for loose or cracked wires. If power tool or accessory
is dropped, inspect for damage or install an undamaged
accessory. After inspecting and installing an accessory,
position yourself and bystanders away from the plane of the
rotating accessory and run the power tool at maximum no-
load speed for one minute.

Damaged accessories will nor-

mally break apart during this test time.

Wear personal protective equipment. Depending on appli-
cation, use face shield, safety goggles or safety glasses. As
appropriate, wear dust mask, hearing protectors, gloves
and workshop apron capable of stopping small abrasive or
workpiece fragments.

The eye protection must be capable

of stopping flying debris generated by various operations.
The dust mask or respirator must be capable of filtrating
particles generated by your operation. Prolonged expo-
sure to high intensity noise may cause hearing loss.

Keep bystanders a safe distance away from work area. Any-
one entering the work area must wear personal protective
equipment.

Fragments of workpiece or of a broken acces-

sory may fly away and cause injury beyond immediate
area of operation.

Character

Unit of measure,
international

Unit of measure,
national

Explanation

/min

rpm

Rated speed

Rated voltage

Power input