WSB 20-180 / WSB 20-230 / WSB 25-180 X / WSB 25-230 X
19
EN
At a glance.
The following numbering used for the
operating elements relates to the figures
at the beginning of this Instruction Manual.
1 Switch
For switching the power tool ON and OFF,
ON/OFF switch (1a),
Lock-off (1b).
2 Quick-clamping lever
For clamping the accessory.
3 Clamping unit
For clamping the accessory.
4 Guard with clamping lever (4c)
For loosening/tightening the guard.
5 Auxiliary handle
Hold the power tool with both hands.
6 Adjustable handle
Changing the position of the handle,
Unlock button (6d).
7 Standard accessories
Auxiliary handle (7e),
Guard (7f),
Clamping unit for grinding and cutting
wheel (7g).
Only part of the accessories described or shown
in this instruction manual will be included with
your power tool.
For all the parts applicable for your power tool,
please see the spare parts list.
Intended use of the power tool.
This power tool is intended as a hand-guided
grinder for commercial use, for dry-sanding/
grinding and cutting metal and stone in weather-
protected environments using the application
tools and accessories recommended by FEIN.
Operating instructions.
Mounting the auxiliary handle (Figure 5).
➤
Screw the auxiliary handle tightly onto
the left or right side of the power tool,
depending on the working method.
Mounting the guard (Figure 4).
➤
With the clamping lever (4c) open,
insert the nose of the guard (4) into the
groove on the power tool.
➤
Swivel the guard (4) into the required
working position and clamp the guard (4)
using the clamping lever (4c).
➤
If the guard (4) is loose when the clamp-
ing lever is notched, tighten the nut while
the clamping lever (4c) is open.
Adjustments.
Adjusting the guard (Figure 4).
➤
Unclamp the clamping lever (4c).
➤
Swivel the guard (4) into the required
working position.
➤
Notch in the clamping lever (4c).
Adjusting the grip (Figure 6).
The grip (6) can be locked in 4 positions.
➤
Press the lock-off button (6d). Make
sure that the lock-off (1b) is not pressed.
➤
Turn the grip (6) and notch it in the
required position.
Changing the tool.
Attaching or changing the accessory (Figure 3).
Use:
– the clamping unit for the grinding and cutting
wheel for work using a grinding and cutting
wheel
– the clamping unit for elastic backing pads
(accessory) for a fibre sanding disc combined
with the elastic backing pad
➤
Loosen the quick-clamping lever (2) and
swivel it to the stop.
3 41 01 020 06 3.book Seite 19 Dienstag, 10. Mai 2005 11:34 11
