10
HDMI only audio output
A downscaler is automatically activated at this output if the source device outputs an Ultra HD
signal. The original 2160p 50/60Hz signal is downscaled to 1080p 50/60Hz. This makes the
signal compatible with an older AV receiver with HDMI 1.3 interface. The signal at the HDMI TV
output is not affected.
Note:
An input signal with 1440p is not scaled. This format might not be processed by all AV
receivers.
Installation and operation
1. Connect the HDMI signal source (e.g. Bluray player) to the HDMI input.
2. Connect an HDMI display (e.g. TV, monitor or video projector) to the HDMI TV output.
Connect an AV receiver or sound bar to HDMI Audio output.
3. You can use the audio outputs digital optical and 3.5 mm jack alternatively or additionally.
4. Connect the power supply unit to the HDMI HD Audio Extractor and plug it into a power sock-
et. Or use the USB adapter cable for power supply. Then switch on the TV and sound system,
then the media player.
Caution:
Make sure that the HDMI plug contacts are not dirty or damaged when connecting or
disconnecting the HDMI cables. Make connections without power and switch on the devices only
after connecting them. Please also pay attention to a good quality of the HDMI cables. Good
cables usually have a large diameter. The HDMI cable length shall not exceed 5 m for 4K, unless
you use special active cables.
•
Please do not cover the housing or install the device to avoid overheating.
•
Keep away from heat sources, water and moisture.
•
Do not place heavy objects on the device or the connection cables.
•
Do not open or drill holes in the housing.
•
Use only the supplied power adaptor or ensure identical performance data when replacing.
•
Use only a soft, dry cloth to clean the surface of the unit. Please do not use aggressive clean-
ing agents, gasoline or the like.
•
If the unit will not be used for a longer period of time, please unplug it from the mains.
Service
The device must be checked by qualified personnel in the following cases:
•
Objects or liquids have penetrated the device.
•
The unit is not operating normally or performance has changed.
•
The unit has been dropped or the housing is damaged.
Do not attempt to repair or open the unit yourself. Contact trained specialist personnel or FeinTech
