FEIT ELECTRIC COMPANY | PICO RIVERA, CA | (800) 543-3348 | FAX (562) 908-6360 | www.feit.com
Wall Installation
MODEL S10DFL/3WY/DD/SS
WARNING: TURN OFF THE MAIN POWER AT THE CIRCUIT BREAKER BEFORE
INSTALLING THE FIXTURE IN ORDER TO PREVENT POSSIBLE ELECTRIC SHOCK.
1. Unscrew the canopy mounting nuts and
remove the fixture crossbar (Fig A).
2. Pull the power supply wires to the side and install the fixture
crossbar onto the J-box with the screws provided (Fig B).
3. Using the wire nuts provided, connect the bare grounding
wires from the fixture to the house ground wires. Connect
the white fixture wire to the neutral house wire. Connect the
black fixture wire to the power supply wire (Fig C).
Note:
Select your preferred color temperature by using
the switch behind the fixture’s canopy.
4. Adjust the crossbar fixture screws and tighten the center
swivel screws. Insert the canopy holes through the fixture
mounting screws (Fig D).
5. Position into place and secure the fixture by installing the
washers and canopy mounting nuts. Place rubber washers
onto fixture, then tighten the nuts (Fig E).
6. Caulk between the light fixture and the wall surface with a
silicone sealant (not included).
Fig A.
Fig B.
Fig C.
Fig E.
Fig D.
Black
Green
White
WARNING:
This luminaire should be installed by qualified electrician.