Guilin Feiyu Electronics Co., Ltd.
Page | 4
Step 3: Install ESCs and flight pack Power connector
1.
After soldering the 3 arms, install the 6 ESCs by connecting the 3 ESC output wires
to the 6 motors. At this juncture, don’t worry about the motor rotation direction.
2.
Run both the ESC servo lead and power supply to the middle fuselage. Connect the
power input leads to the JST connectors and exit the T-Plug as shown below.
3.
After completing ESC install, you may proceed with the middle plate installation.
Don’t forget to pull the 6 servo leads from the ESCs through the middle plate for
later connection to the FY91Q.
4.
After installing the middle plate, you can proceed to install the flight controller
( FY91Q) via the damper mount / anti-vibration pads.
5.
Install your RC Receiver and complete the connection with the FC as per the FC’s
manual.
M3
×
30mm Pillar
M3
×
5mm
Scoket Screw
Front
M3
×
25mm Pillar
Power cable through
Round hole
6 ESCs wires
through portal
