Guilin FeiYu Electronic Technology Co., Ltd
Guilin FeiYu Electronic Technology Co., Ltd http://www.feiyudz.cn E-mail：service@feiyu-tech.com Page
2
B.
Use the data radio and Remote Adapter to connect to FY-31AP.
In this way, you need not connect to RC receiver. The remote adapter
transforms the signal offered by RC receiver into digital data, The signal
would be transmitted to FY-31AP by data radio. You can not only set the
value at any time via data radio, but also extend the remote distance, this
distance is determined by the radio communication distance. As a result, you
can realize FPV for farther distance easily. Without receiver, the connecting
would be simple, but there will be some delay when you control the flight.
Show as following:
C.
Use two receiver system
use two same frequency receiver one installed in the Remote Adapter,
another is installed on the aircraft. Such use is the premise of the two
receiver can be operated at the same time by RC, and two receiver , FY-31AP
and Remote Adapter connection must correspond to the channel. During
the operation FY-31AP can only receive one receiver signal, through GCS
"RC" (or "DRRC") button to switch.
Installation instance photos
A:
B:
C:
Remote adaptor introduction
The main function of remote adaptor board is to send the digitalize
output signal of the remote receiver to FY-31AP through data radio, at the
same time send the control instructions of the GCS to FY-31AP through data
radio, and send the flight trace and flight parameters which sent back by
FY-31AP to GCS. Remote adaptor board includes the port with receiver, the
port with data radio and the port with PC, the typical connecting diagram is
as following:
Remote Adapter FY-602 data radio
Name
Function
RADIO
Connect to the data radio
PC
Connect to the PC serial port
AIL
Aileron input
ELE
Elevator input
THR
Throttle input
RUD
Rudder input
CH5
Channel 5 input
CH6
Channel 6 input
CH7
Channel 7 input
CH8
Channel 8 input
Data
Radio
Data
Radio
PC
GCS
USB - TTL
Remote
Adapter
RC Receiver
