22
!
Planer-Thicknesser
A 941 / AD 941 / AD 951
6 Transport, packaging and storage
6.1 Safety instructions
Warning! Risk of material damage!
The machine can be damaged or destroyed if it is subjected to improper handling during transport.
There is a risk of injury due to falling parts while transporting, loading or unloading the machine.
For this reason the following safety instructions must be
observed:
• Never lift loads over a person.
• Always move the machine with the utmost care and
precaution.
• Only use suitable lifting accessories and hoisting
devices that have a sufficient load-carrying capacity.
• The machine may never be transported on protruding
machine elements (e.g. thicknesser table).
• Consider the machine‘s centre of gravity when trans-
porting it (minimise the risk of it tipping over).
• Take measures to prevent the machine from slipping
sideways.
• Ropes, belts or other hoisting devices must be
equipped with safety hooks.
• Do not use torn or worn ropes.
• Do not use knotted ropes or belts.
• Ensure that ropes and belts do not lie against sharp
edges.
• Transport the machine as carefully as possible in
order to prevent damage.
• Avoid subjecting the machine to shocks.
When transporting the machine overseas, ensure
that the packaging is airtight and that a desiccant is
added to protect the metal parts against corrosion.
Transport, packaging and storage
6.2 Storage
Store packed items only under the following conditions:
• Do not store outdoors.
• Store in a dry and dust-free environment.
• Do not expose to aggressive substances.
• Protect from direct sunlight.
• Avoid subjecting the machine to shocks.
• Storage temperature: –10° to +50° C
• Maximum humidity 60 %.
• Avoid extreme temperature fluctuations
(condensation build-up).
• Apply a coat of oil to all bare machine parts (corro-
sion protection).
• When storing for a period longer than 3 months, ap-
ply a coat of oil to all bare machine parts (corrosion
protection). Regularly check the general condition of
all parts and the packaging. If necessary, refresh or
re-apply the coat of anti-corrosive agent.
• If the machine is to be stored in a damp environment,
it must be sealed in airtight packaging and protected
against corrosion (desiccant).
Note:
Keep items sealed in their packaging until they are assembled/installed and be sure to observe the stacking
and storage symbols on the outside of the packaging.
Summary of Contents for AD 941
