60
0
10
5
0
10
5
10 5
0
10 5
0
10 5
0
10 5
0
0
10
5
1mm
!
AD 951
AD 941
Planer-Thicknesser
A 941 / AD 941 / AD 951
Check the planer knives:
1.
Prepare two gauges according to the illustration
opposite
2.
Set the gauges at “0” on the outfeed side of the
planer table edge on the left and right ends of the
cutterblock
3.
Turn the cutterblock manually
4.
The planer knife should move the gauges 2 to 3 mm
(Manufacturer’s settings)
5.
Should the setting not be correct:
Receiver-side of the planer table is misaligned
See chapter entitled >Making adjustments and pre-
parations<
Adjusting the height of the receiver side of the planer
table:
It may be necessary to readjust the joint if the planer
knives have been changed or replaced.
See chapter entitled >Making adjustments and prepara-
tions<
11.6 Resharpen or replace the planer knife.
Fig. 11-2: Check the planer knives
11.5 Use motor protection device
Fig. 11-1: Motor protection switch button
The machine is fitted with a motor protection unit.
The motor safety switch trips if the motor of the electrical
height adjustment is overloaded.
1.
Press the motor safety switch.
2.
Clean height guide and height spindle
3.
Lubricating the height spindle.
See chapter entitled: >Service<
!
Motor protection switch button
Attention! Risk of injury! The planer knives are razor sharp.
Handle the planer knives with the utmost care.
Especially when turning the cutterblock by hand.
Faults
Summary of Contents for AD 941
